Ahh man that’s a pain, my old notebook has no sata and only 32gb of emmc (which I’m tempted to remove and add a larger chip), but it’s only being used for my 3D printer so it’s not really a pressing need yet.

Try booting your installer without UEFI - I have an old x99 WS IPMI board I spun up with NixOS and has so many issues using the EFI / UEFI installer.

Admittedly that thing pulls 60w at idle, so promptly turned it off 😅

Don’t make excuses for the rat, he’s born into privilege and wants to keep it that way.

The bloke parades around expecting people to believe he’s a top tier gamer, being able to put in 16+ hours a day grinding at POE2 whilst being a CEO of multiple companies. All the while not being able to comprehend one of the most used interfaces on that platform.

But yeah nah, he’s a good bloke. I’m sure he’s done something good in he’s lifetime.

Intel made some massive mistakes with their post 14nm nodes, they overextended and fell on their own sword.

Admittedly what Intel were aiming for with their “10nm” node had higher density than tsmc’s “7nm” (from memory), considering the timeframe that would have been another massive leap for Intel; and if they had pulled it off AMD would be struggling like the bulldozer days.

22nm to 14nm Intel were on fire, almost seemed untouchable for quite some time. X99 was (in my eyes) the biggest leap in the right direction and probably their best consumer platform ever released. Huge cache, moar cores, pcie lanes for days and a refresh on their latest node (6950x).

Computers is a fucking hot song, the drums are on point, the buildup and energy screeching about vr porn, the singularity and black holes until it all halts for a sax solo. Don’t forget 3G.

You lot in the states need more of this and less of diddly tromp.

CLOWNC0RE

Agreed. When I was playing that game Bumble for me was a much more effective platform. Tinder is horrible, just a cesspool of low moral high ego monkeys.

Admittedly my marriage started from a one night stand / hookup at a bar with someone visiting from 400km away, so these apps never paid off in the long term for me.

Depends on the material. ABS would be a decent material for this application - as long as you have a decent enough setup to scrub / clean the air in the chamber / room.

PLA would have a hard time in that position, PETG might be OK, Nylon may creep after too many heat cycles. Depending on how hot those parts get this is.